240 Epoxy Mount 3/16"
The solid surface 240 Epoxy Mount is designed for installing materials too brittle to hold a screw. Some examples would be thin panels, Corian, MF, sculpted panels, acrylics, light metal panels, glass and solid surfaces. The 240 Epoxy Mount work with virtually any material that will accept an epoxy. The perforated mild-steel mounting plate can be epoxy-mounted to almost any surface with high strength and predictability. The small perforations improve mechanical adhesion to the epoxy.
The 240 Epoxy Mount is made from a steel pin welded to a zinc coated steel plate. The 240 Epoxy Mount head is 3/16" Mounting Bolt, that works with the 210 Lock.
The 240 Epoxy Mount can be attached to various panels with a 3M Scotch-Weld 110 Epoxy. The 211 Alignment Pins 3/16" can be used to mark the mount locations onto panels.
The 240 Epoxy Mount is diameter 0.990" or 0.010" less than 1" and just a bit less than 1/16" thick. If installed in a pocket 1" x 1/16" pocket works well.
Cost & Benefit Estimates
Mounting Solid Surfaces to a walls, and waiting until the glue sets is time consuming and frustrating work. It takes approximately 6 hours per 30” x 96” section (not including the seams). With practice, this can be reduced by about 2 hours per sheet.
Order Here: Use Dropbox to select Pack Size
Product Specifications230 Epoxy Mount, Spec, 1-28-19 (pdf)
SKU 230, Epoxy Mount Specifications, V1 (pdf)
Downloads230 Epoxy Mount Installation Guide (pdf)
SKU 230, Epoxy Mount (jpg)
SKU 230, Epoxy Mount (pdf)